Himsa NOAHlink - Page 33

NOAHlink Users Manual
30
The following table describes how to use the Advanced Settings tab:
SETTING
OPTION
PROCEDURE
NOAHlink
power off
time
Set the time
length before an
idle NOAHlink
powers off
 Select the length of idle time
before NOAHlink powers off
OR:
 Select Off for NOAHlink to
remain on indefinitely
HI power
status
Turn hearing
instruments on
automatically
with NOAHlink
 Select On to turn on hearing
instruments automatically when
NOAHlink powers on
 Select Off for hearing
instruments to be turned on
through the fitting module
Power on
when
leaving
cradle
Set NOAHlink to
power on
automatically
when removed
from its cradle
 Select On for a previously
powered on NOAHlink to
power on automatically when
removed from its cradle
Driver
Change the
driver
 Click Change. A File Menu
appears.
 Select the driver after browsing
for its location
 Click OK
COM Port
Settings
Scan ports to
locate
NOAHlink
NOTE: Only select new values if
your system CANNOT
locate NOAHlink
 Use the pull-down menus at
COM Port low and COM Port
high to select new values.