Monitoring Voltage Fluctuations
20
Refer to "Analysis" (p. 26) for analysis methods.
Make input channel settings on the CH screen.
1
2
Setting Example
Channel: CH1, Input: Voltage, Range: 10V
Make other settings as necessary.
Disp Span: Position, 0 pos: 0% (displays zero volts at the bottom of the screen)
Scaling: Dec, 2-pt
Cnv 1: 0 V to 0 V , Cnv 2: 10 V to 150 V for display
0 V
10 V
0 V
150 V
Select
Apply
3 Start and Stop Measurement
Press the START/STOP key.
The specified data length is record-
ed on the CF card.
Recording stops seven days after
starting.
To interrupt recording, press the START/STOP key again.
To Next Page
Loading...
