Make input channel settings on the CH screen.
1
2
Setting Example
Channel: CH1, Input: Tc, K (Thermocouple)
RJC: Int
Set the open-circuit detection and display range as neces-
sary. Enable [Burn Out] (set to [On]) to detect a broken ther-
mocouple. When a thermocouple is broken, its waveform
appears at the top of the screen as shown at the right.
The default settings for the non-
framed items can be left as-is.
Change as needed.
Indicates a broken
wire.
Select
Apply
Press the START/STOP key.
In this case, measurement data is
recorded until you press the START/
STOP key again.
To Next Page
Loading...
