EasyManua.ls Logo

Hipresso DP2002 - 5. INSTALLATION; 4.3 Accessories; 5.1 Installing the appliance

Hipresso DP2002
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4.3 Accessories
The following accessories are supplied with the appliance
Power cord
1
Milk tube
1
Manual
1
Spoon
1
Brush
1
5. INSTALLATION
5.1 Installing the appliance
About Place
When you install the appliance, you should respect the following safety warnings to avoid damage to
the appliance:
The distance between the power outlet specified in the installation drawing and the appliance
positioning shall not exceed 1m .
To leave certain space for convenience of operation and maintenance:
(1) Please leave enough space above the appliance to fill the coffee beans
(2) The appliance gives off heat. Please leave a space of at least 5cm between the surfaces of
the appliance and the side and rear walls.
About Environment
When you install the appliance, you should respect the following safety warnings to avoid damage to
the appliance:
(1) Keep surroundings at a temperature between 10 to 40 (50 to 104 )
(2) Relative humidity shall not exceed 80% rH
(3) The coffee machine is designed for indoor use only. Do not use it outdoors to prevent it from
being affected by weather (rain, snow, frost and freezing)!
(4) If the environment temperature is below 0 , please contact customer service before
installation.
About Power Supply
The appliance must be earthed according to relevant national regulations. Make sure the voltage of
the main power supply corresponds to the value indicated on the appliance’s rating label.
Danger of electric shock
Please respect the following safety warnings:
(1) Do not use the appliance if the power cord is damaged. Have the cord or socket replaced by a
qualified professional.
(2) Extension cord is not recommended to be used. If extension cord must be used (minimum
cross section: 1.5mm²), please follow the manufacturer's data (Instruction Manual) of the power cord
and local regulations.
(3) Make sure the power cord would not trip any person. Do not let the power cord go through
sharp edges or hang in the air. Do not clamp the cable. Moreover, the power cord must be placed in
such a way that it cannot be damaged by hot surfaces, oil or corrosive detergent.
(4) Do not lift or pull the appliance through power cord. Do not unplug from the socket by pulling
the power cord. Never touch power cord or plug by damp hands. Do not insert a wet plug into the
socket!
About Water
Poor water quality may damage the appliance. Please respect the following safety warnings:
(1) Never fill corrosive water into the water tank.