Hirschmann PAT DS 85/0002 - Page 23

© Hirschmann Rev. G 10/05/15 190166_G.DOCXG
17
There are 6 LEDs on the front panel of the device, which indicate the status of various operating conditions.
The meaning of the signals can be taken from the table:
off:
lights:
flashes slowly:
flashes rapidly:
No supply
voltage
present
Supply voltage is
present
Hoist limit switch has
triggered
or
radio link to a hoist
limit switch interrupted
No sensor
registered to
this channel
Sensor registered to
this channel and ready
for operation
During the
registration of a
new hoist limit
switch
or
sensor in ‘sleep’
mode
Radio link to the
sensor on this
channel
interrupted
Batteries of the sensor
on this channel are
almost exhausted
Replace the batteries
soon!