Hirschmann PAT DS 85/0002 - Troubleshooting Moisture

© Hirschmann Rev. G 10/05/15 190166_G.DOCXG
47
18 ERROR CODES
The following Error Code Table gives a brief description of Error Codes elimination. Refer to the
noted sections for detailed Troubleshooting information.
Error Code
Error
Possible Cause
Elimination
E01
Fallen below radius
range or angle range
exceeded
 Fallen below the
minimum radius or gone
past the maximum angle
specified in the respective
load chart due to luffing
up the boom too far
 Luff down the boom to a
radius or angle specified in
the load chart.
E02
Radius range
exceeded or fallen
below angle range
 Gone past the maximum
radius or fallen below the
minimum angle specified
in the respective load
chart due to luffing down
the boom too far
 Luff up the boom to a radius
or angle specified in the load
chart.
E03
Non-permitted slewing
zone (no load area)
 The slewing zone with
load is not permitted
 Slew to permitted area
E04
Operating mode not
acknowledged or non
permitted slewing
zone
 An incorrect operating
mode has been selected
 Set the correct operating
mode for the operating
configuration in question.
Refer to Operator’s
Handbook.
 The boom is in a non-
permitted slewing zone
 Slew the boom to a
permitted area. Refer to
Section 8.
E05
Prohibited length
range
 Boom has been extended
either too far or not far
enough, e.g. if it is
prohibited to go beyond a
certain maximum boom
length or with load curves
for jibs where the main
boom has to be extended
to a certain length
 Extend/retract boom to the
correct length
 Length sensor adjustment
has changed, e.g. the
cable slid off the length
sensor reel.
 Retract boom. Check the
prestress of the cable reel
(cable must be taut). Open
the length sensor and
carefully turn the length
sensor pot counterclockwise
until the detent by means of
a screw driver
 Clutch between length
sensor pot and drive is
defective
 Replace the complete clutch
including drive wheel and
adjust length sensor pot as
described above