Hirschmann PAT DS 85/0002 - Service Screen for Sensor Calibration; Activating the Service Screen for Sensor Calibration; Zero-Setting the Transducer Inputs

To Next Page

To Previous Page

Service Manual DS 85

16 SPARE PART LISTINGS

16.1 CONSOLE/CENTRAL UNIT

PART NO. 031-300-060-455

NO. PART NO. QTY DESCRIPTION

1 024-085-100-002 1 FRONTFACE, PREASSEMBLED

2 024-000-050-002 1 HOUSING, DS85

3 024-000-100-095 1 CENTRAL UNIT ACCY, MEMBRANE VENT, PG11

4 024-050-300-101 1 MAINBOARD, CAN w/o FLASH E-EPROM

5 024-050-300-106 1 CONNECTION BOARD

6 031-300-050-223 2 FUSE, 2 AMP

7 024-050-300-110 1 KEYBOARD

8 050-000-100-271 1 LC DISPLAY UNIT

9 092-000-060-391 1 CAN BUS CONNECTOR, 5-PIN FEMALE, 120 ohms

10 024-050-290-101 1 RIBBON CABLE ASSY

11 031-300-060-700 1 CABLE ASSEMBLY, W/ GROUND CONNECTIONS

12 031-300-060-696 1 MOUNTING ASSEMBLY, 1.5” BALL

13 031-300-050-624 1 MOUNTING ARM, 4.63” DOUBLE SOCKET FOR 1.5” BALL

14 092-000-060-390 1 CAN BUS TERMINATOR, 120 OHMS

Cable assemblies not included with console:

1. Power Cable assembly (wiring harness)

PART NO. 031-300-060-443

2. CAN bus from console (90° connector) to pressure

transducer block PART NO. 031-300-060-453

3. CAN bus from pressure transducer to angle sensor box

PART NO. 10968 *(not shown)

See next page:

Other manuals for Hirschmann PAT DS 85/0002