Redundant coupling
32
3.2
Configuring the redundant coupling
Redundancy L2E
Release
4.1
03/08
The coupling mode indicates the type of the connected network.
In the “Coupling Mode” frame, select (see fig. 12)
– “Ring Coupling” or
– “Network Coupling”
Figure 12: Selecting the coupling mode
Select “Ring coupling” if you are connecting a HIPER-Ring.
Select “Network Coupling” if you are connecting a line structure.
Delete coupling configuration
The “Delete coupling configuration” button in the dialog allows you
to reset all the coupling settings of the device to the state on delivery.
To Next Page
Loading...
