Rapid Spanning Tree
Redundancy L2E
Release
4.1
03/08
4.6
The Rapid Spanning Tree Protocol
65
Note: The price to be paid for this fast reconfiguration is the risk that data
packets may be duplicated or mixed up during the reconfiguration phase. If
this is unacceptable for your application, switch to the slower Spanning Tree
Protocol or select one of the other, faster redundancy procedures described
in this manual.
4.6.5 Configuring the Rapid Spanning Tree
Set up the network to meet your requirements.
Note: Before you connect the redundant lines, you must complete the
configuration of the RSTP.
You thus avoid loops during the configuration phase.
Select the Redundancy:Rapid Spanning Tree:Global dialog.
Switch on RSTP on every device
To Next Page
Loading...
Need help?
General
