HIS H6000 - General Safety

HIS Business Manufacturing Company
Tel: (619) 447-0009 (800) 292-9831 Fax: (619) 447-4695
Web Site: www.hizbiz.com Email: sales@hizbiz.com
4
General Safety Instrucons
HIS Cable Puller is
designed for producvity
and safety. One person
can easily and eciently
transport, set up and
pull cable. Always
understand the funcon
of the cable puller
before operang. Only
experienced journeymen
should operate cable
pulling equipment.
The cable puller operator should stand o to the side of the puller away
from the line of pull. Always stay clear of the hazard area.
Common Sense, Skill, Safe Working Pracces and Cauon can help avoid most injuries and keep everyone working!
WARNING! Not intended to be used for pulling live electrical cable
Always read instrucons before operang puller
Always inspect puller before operang
1. Inspect cable puller, power lines and surrounding area.
2. Clean up cluered work area before seng up puller.
3. Inspect cable pulling rope. Rope and eyelet must be in
excellent condion. Use high quality, high grade low
stretch cable pulling rope.
4. Never stand on or near the coiled pulling rope as it lays
on the ground.
5. Always pay close aenon to cable pulling. Never let
anyone or anything distract this operaon, unless an
emergency situaon occurs.
6. Never use in water or in dangerous environments.
7. Think SAFETY, SAFETY, SAFETY!
8. Aer pull is completed, dismount puller, clean up and
inspect equipment before storing.
Transporng HIS Cable Puller
Before moving the cable puller, inspect
the equipment to make sure that the
extension arms are secured in the
locking posion using the locking axle
shas provided. Check to be sure power
cord and foot switch is contained with
puller and not loose.
When rolling the cable puller steady the
axle using your foot as you lean the unit
back to nd it’s natural pivot point at
about waist high or 34”. The unit then
becomes easy to transport in either
direcon without exerng undue stress.
When loading and unloading cable
pullers using a hoist, secure one end of
a strap to the handle on the capstan /
motor housing. Loop the other end
through the locking axle sha
NOTE: When seng up cable puller and puller arms BE AWARE OF PINCH POINTS