SAFETY SUMMARY
●
Do not step or put any material on the product.
●
Do not put any foreign material on the unit or inside the unit.
●
Provide a strong and correct foundation so that;
a. The outdoor unit is not on an incline.
b. Abnormal sound dose not occur.
c. The outdoor unit will not fall down due to a strong wind or earthquake.
WARNING
CAUTION
●
Do not use any sprays such as insecticide, lacquer, hair spray or other ammable gases within
approximately one (1) meter from the system.
●
If circuit breaker or fuse is often activated, stop the system and contact your service contractor.
●
Check that the ground wire is securely connected. If the unit is not correctly grounded, it lead electric
shock. Do not connect the ground wiring to gas piping, water piping, lighting conductor or ground wiring
for telephone.
●
Connect a fuse of specied capacity.
●
Before performing any brazing work, check to ensure that there is no ammable material around.
When using refrigerant be sure to wear leather gloves to prevent cold injuries.
●
Protect the wires, electrical parts, etc. from rats or other small animals.
If not protected, rats may gnaw at unprotected parts and which may lead to a re.
●
Fix the cables securely. External forces on the terminals could lead to a re.
●
Provide a sufciently strong foundation. If not, the unit may fall down and it may lead to injuries.
●
Do not install the unit in a place where oil, vapor, organic solvent and corrosive gas (ammonia, sulfur
compound and acid) may be present in quantities.
It may cause refrigerant leakage due to corrosion, electrical shock, deteriorated performance and
breakage.
●
Perform electrical work according to Installation Manual and all the relevant regulation and standards.
If the instructions are not followed, an electrical shock and re may occur due to insufcient capacity and
inadequate performance.
●
Use specied cables between units and choose the cables correctly. If not, an electrical shock or re may
occur.
●
Ensure that the wiring terminals are tightened securely with the specied torques. If not, generating re or
electrical shock at the terminal connection part may occur.
To Next Page
Loading...
Need help?
General
