17
food is placed within the appliance to allow sufficient
ventilation. Ensure that door is fully closed. To remove the
frost, please refer to the
“
”
too warm
You may have left the doors open too long or too frequently; or
the doors are kept open by some obstacle; or the appliance is
located with insufficient clearance at the sides, back and top
too cold
Increase the temperature by following the “controls panel”
chapter.
Doors can’
easily
Check whether the top of the refrigerator is tilted back by 10-
15mm to allow the doors to self close, or if something inside is
preventing the doors from closing.
Reversing the door
The side in which the door opens can be
changed from the right side (as supplied)
to the left side, if the installation site
allows for it. Tools you will need:
Note: Before you start lay the freezer on
it’s back in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the freezer. To
reverse the door. The following steps are
generally recommended.
1.Stand the freezer upright.
Remove the screw hole cover and upper
hinge cover(right)as follow diagram.
2. Remove the three screws as follow
diagram. Lift the right upper hinge part.
3.Lift the door and place it on a padded
surface to prevent scratching.