Hisense HS6130 - Troubleshooting

Troubleshooting
ActionType of fault on the dis-
play
Clear the drainage pump. See the chapter Care and
cleaning. If the problem persists, call the service
department.
OverfillingF10
See “Water remains in the dishwasher” in the table
“Problem” below. If the problem persists, call the service
department.
Water outlet faultF11
Check that the water tap is on. Check that the outer filter
on the inlet hose is not blocked. See Unblocking the inlet
hose filter in the chapter Care and cleaning. If the problem
persists, call the service department.
Water inlet faultF12
Turn off the water tap and call the service department.Inlet valve leakageF40
Clean the coarse and fine filters. Check that the outer
filter on the inlet hose is not blocked. Also check that the
drainage hose is fitted in accordance with the installation
instructions. If the problem persists, call the service
department.
Water level faultF52
Turn off the water tap and call the service department.OverfillingF54
Call the service department.Circulation faultF56
Press any button to clear the error message.
ActionPossible causesProblem
Wait a moment then try
again.
You have pressed the
buttons too soon after
opening the door.
The buttons do not react
when pressed.
Clean with a dry or slightly
damp cloth.
The buttons are dirty.
Open the door. The buttons
only react to use when the
door is open.
The door is closed.
19