Settings
1. Press .
2.
To open the dishwasher's settings menu, press and hold and until SEt is shown on the display.
3.
Press to step through the settings menu.
4.
Press to step through the alternatives.
5.
Confirm the selected setting by pressing .
6. To exit the menu, step through it or press .
Confirm / Next settingSelect alternative
Open the dishwasher's settings menu
AlternativesSettings
You can activate the Automatic child lock setting to prevent
children from starting the dishwasher.
1:00 (Off)
1:01 (On)
Automatic child lock
(CL)
To temporarily deactivate or activate the Automatic child
lock setting, press and hold for three seconds.
CL (Child Lock) will be shown on the display when pressing
the control panel. (To unlock, press and hold for three
seconds.)
A beep confirms that the control panel has been pressed.2:00 - 2:03Sounds
A beep indicates when a dishwashing program has ended.(2:00 Off)
Error messages are always indicated by a loud buzzer.
Setting for rinse aid dosage. The rinse aid dispenser can
be adjusted between 3:00 (Off) and 3:05 (High dosage).
3:00 - 3:05
(3:00 Off)
Rinse aid
Increase the rinse aid dosage:
• If the dishes have water marks.
Decrease the rinse aid dosage:
• If the dishes have a sticky white/blue film.
• If the dishes are streaked.
• Build-up of foam. If you have very soft water, the rinse
aid can be diluted 50:50 with water.
Pre-selected at factory: 3:04
Adjusting the water softener. Select a setting depending
on the hardness of the water supply. It is important that
this setting is correct!
4:00 - 4:09
(4:00 Off)
Water hardness
23
To Next Page
Loading...
