Installing your new appliance
4 Flush the tubing. Turn the main water.
supply on and flush out the tubing until
the water is clear. Then, shut the water
off at the water valve after about a
quart of water has flushed through the
tubing.
Saddle-type
shutoff valve
Packing
nut
Outllet valve
Compression
nut
1/4” Extension
tubing
Ferrule (sleeve)
5 Connect the extension tubing line.
with the line on the back of the fridge
with the coupler. Fully insert the
extension tubing into the coupler, and
then insert the clip onto the coupler to
lock up the tubing. Do the same with
the other end. After both of clips are
inserted, check the line to make sure it is
held firmly by the clips.
Clip
Water
line
Coupler
Water
line
Ensure that the water line does
not get pinched or bent when
installing. This can result in
improper water flow through the
line and will affect the
functionality of the fridge.
Note
6. Turn the water on and check for
leakage.
Check to see if leaks occur at the
water line connections.
Caution
3. Connect 1/4 extension tubing to"
shutoff valve outlet.
12
To Next Page
Loading...
