Hisense RB390N4BC2 - Reversing the Door

10
Reversingthedoor
Thesideatwhichthedooropens
canbechanged,fromtherightside
(assupplied)totheleftside,ifthe
installationsiterequires.
Whenreversing thedoor,
theappliancemustnotbeconnected
tothemains.Ensurethattheplugis
removedfromthemainssocket.
Whenrequired,tilttherefrigerator
backinordertogainaccesstothe
base,youshouldresttheappliance
onsoftfoampackagingorsimilar
materialtoavoiddamagingthe
backboardoftherefrigerator. To
reversethedoor,thefollowingsteps
aregenerallyrecommended.
Differentmodelsmaycorrespondto
different pictures.Modelswillbe
writteninthepicture.Ifsomeparts
arenotshowninthepicture,please
ignoretherelevantdescription.
1.Standtherefrigeratorupright.
Opentheupperdoortotakeoutall
doorracks(toavoidracksdamaged)
andthenclosethedoor.
Warning!
Toolsyouwillneed
●
2.Removepart loosepart from
thetoprightsideofrefrigerator.
3.Removescrews andhinge
.Whentherefrigeratorwith
displayondoor,youneedtopass
connector throughtheholeof
hinge (Pleaseholdupperdoorby
handwheninstalling).
①, ②
③
①
②
②.
Not provided
8mm socket wrench
Thin-blade screwdriver
8mm wrench
Cross-shaped screwdriver
Doorracks
MODEL WITHOUT DISPLAY
① screwsSpecialflange
Upperhinge②
MODEL WITH DISPLAY
① screwsSpecialflange
Upperhinge
Electricalconnector
②
③
① screwsSelf-tapping
Upperhingecover②