right upper hinge part
special flange
selftapping screws
4.Remove the upper hinge axis, transfer it to
reversed side and tighten securely, then put
it in a safe place.
5. Lift the upper door and set it on a non
scratching surface with the outside
up,Unscrew the selftapping screw which is
used for fixing the door stop and install the
door stop on the left side.
NOTE: When removing the door, watch for
washer(s) between the ceter hinge and the
bottom of the freezer door that may stick to
th
e door. Do not lose.
6. Unscrew the two special flange
selftapping screws which are used for fixing
the middle hinge part, then remove the
middle hinge part that hold the lower door in
place.
7. Lift the lower door and set it on a non
scratching surface with the outside
up,Unscrew the selftapping screw which is
used for fixing the door stop and install the
door stop on the left side.
NOTE: When removing the door, watch for
washer(s) between the ceter hinge and the
bottom of the freezer door that may stick to
the door. Do not lose.
8. Remove the screw hole cover from the left
holes as illustrated and transfer them to the
uncover holes at the right side.
35
3.Unscrew the special flange self-tapping
screws which are used for fixing
the right
upper hinge part by a 8mm socket driver or
a spanner(please support the upper door
with your hand when doing it ).
9. Lay the refrigerator on soft foam
packaging or similar material. Remove both
adjustable bottom feet parts, and remove
the front feet fixed board and the lower
hinge part by unscrewing the special flange
self-tapping screws.
middle hinge part
special flange
selftapping screws
screw hole cover
screw hole covers
screw hole cover
screw hole covers
front feet fixed board
ajustable bottom
feet part
special flange
selftapping screws
lower hinge part
ajustable bottom
feet part
special flange
selftapping screws
10. Unscrew the bottom hinge axis and
remove it to the hole which is side-by-side
and screw it.
11. Replace the lower hinge part to the left
side and fixing it with the special flange self-
tapping screws. Replace the front feet fixed
board to another side and fixing it with the
special flange self-tapping screws. Install
the ajustable bottom feet parts,
lower hinge part
front feet
fixed board