If you wish to connect hot and cold water supply (Fig.1):
1.
Fix the red marked inlet hose to the hot water tap and to the inlet valve with the
red filter on the rear side of machine.
2.
Fix the other inlet hose to the cold water tap and to the inlet valve with the blue
filter on the rear side of the machine.
Make sure:
a) The connections are tightly fixed
b)
If you wish to connect only the cold fill follow the below instructions (Fig. 2):
1.
You will need a Y-piece connector. This can be purchased from local hardware or
plum b ing supplier.
2. Fix the Y-piece connector to the cold fill tap.
3.
Connect the two inlet valves present on the rear part of the machine to t h e Y -
p i e c e connector using the hoses provided.
Hot / Cold fill fault - For Models with Dual Inlets
Do not invert their position (for example: cold fill into hot inlet valve and vice
versa).
Fig.1
Hot fill
Red inlet valve
Blue inlet valve
Cold fill
Red inlet valve
Blue inlet valve
Cold fill
Y-piece
Fig.2
If the laundry is still too wet at the end of the cycle, remove some articles of laundry
and repeat the spin cycle.
Excessive foam formation may prevent spinning. Use the correct amount of
detergent.
Check that the spin speed selector has not been set to “0”.
27
To Next Page
Loading...
