Ensure that:
All connections are tightly fixed.
Fault description table
Do not allow children to operate, crawl on, be near or inside your washer. Note that
during the wash cycles, the surface temperature of the porthole d o o r m a y increase.
Close supervision of children is necessary when the appliance is used near children.
28
Displayed on Display Window Fault Description
“F01” Water inflow fault
“F03” Drainage fault
“F04”, “F05”, “F06”, “F07”，“F23”
and “F24”
Electronic module fault, overflow or too much
foam.
“F13” Door lock fault
“Unb” Unbalance alarm
a.“F01” displayed on screen
Faucet is fully open and has enough water pressure.
Water inlet pipe is knotted or not.
Filtering net of water inlet pipe is blocked or not (refer to maintenance and repair).
Water pipe is frozen or not.
Press “Start/Pause” key after fault is removed.
If fault occurs again, please contact with after-sale service (refer to after-sale service.).
The machine is not fed with water or insufficient water. Check:
b.“F03” displayed on screen
The washer is not emptied. The washer stops the program being executed. Shut down
the machine and disconnect power supply. Check:
Drain pipe is knotted or not.
Filter in drain pump is blocked or not (refer to the cleaning
of fil
ter in drain pump)
IMPORTANT:
Ensure that
the water has cooled before drainning the appliance.
The drain hose is frozen up.
Plug in the appliance again. If the fault persists, unplug the appliance and contact After-
Sales Service(see “After-Sales Service” ).
To Next Page
Loading...
