820726
14
1
Move the hoses and
undo the screws on
the back of the washing
machine.
Remove the two angular
pieces.
2
Slide the angular
pieces onto the
grove in the blocking rod;
before doing so, rotate
the right angular piece to
the opposite side.
3
Use the angular
pieces to rotate the
blocking rods by 90°and
pull them out.
4
Cover the two holes
through which the
blocking rods were
inserted with plastic
plugs, and redo the
screws that you undid
in step 1. The plastic
plugs are supplied in the
bag with the washing
machine instruction
manual.
INSTALLATION AND CONNECTION
Remove all packaging. When removing the packaging, make sure not to damage the appliance
with a sharp object.
REMOVING THE BLOCKING RODS
Before the first use of the appliance, transport rods must be removed. A blocked washing
machine may be damaged when it is switched on for the first time. Warranty shall be void in
cases of such damage!
820726en.indd 14820726en.indd 14 17. 02. 2021 07:49:2317. 02. 2021 07:49:23
To Next Page
Loading...
Need help?
General