Hitachi Compute Blade 2000 - Page 16

2-4 Preparations
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Pre-setting
To operate a DCB switch module, it is necessary to access to the DCB switch
module via the management module.
The IP address of management modules shipped from the factory is set as below.
Item
Factory setting
IP address of management module
192.168.0.1
Connect the LAN interface connector of the system console and MGMT0 port of the
management module with a LAN cable. When two management modules are
installed, connect the cable to the one with MSR LED lighting up green.
Compute Blade 2000
Compute Blade 500
LAN cable
System console terminal
System console
terminal
LAN cable
MSR