Hitachi Compute Blade 2000 - Page 18

2-6 Preparations
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Common procedure
This section describe pre- or post-execute or common procedure for some
license apply commands actually.
(1)Connect to the management module
First of all, connect to the management module by telnet and so on, and login
with a user ID and password with administrator (admin) privilege.
The user ID and the password of management modules shipped from the
factory are set as below.
Item
Factory settings
user ID
administrator
password
password
Compute Blade 2000
Compute Blade 500
login: administrator  Enter User ID of administrator (admin).
Password: xxxxx  Enter Password of administrator (admin).
BladeSymphony BS500 Management Module
ALL RIGHTS RESERVED, COPYRIGHT (C), 2011, 2012, HITACHI, LTD.
Chassis ID :
Firmware Revision : xxxx-xxxx
(0)$
login: administrator  Enter User ID of administrator (admin).
Password: xxxxx  Enter Password of administrator (admin).
BladeSymphony BS2000 Management Module
ALL RIGHTS RESERVED, COPYRIGHT (C), 2008, 2012, HITACHI, LTD.
Chassis ID :
Firmware Revision : xxxx-x-xxxx
<< System Console Main Menu >>
P. Start OS console session.
SW. Start switch module console session.
S. System command mode.
X. Exit.
(P,SW,S,X) :