1.
Press ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
Selecting an aspect ratio
● ASPECT button does not work when no proper signal is inputted.
● NORMAL mode keeps the original aspect ratio setting.
● The on-screen menu might be displayed outside of the image display area
depending on the adjustment value of the ASPECT, D-ZOOM, KEYSTONE
and KEYSTONE. Changing the values of ASPECT, D-ZOOM,
KEYSTONE and KEYSTONE may x the symptom.
1.
Press SEARCH button on the remote control.
The projector will start to check its input ports as below in
order to nd any input signals.
When an input is found, the projector will stop searching
and display the image. If no signal is found, the projector will
return to the state selected before the operation.
Searching an input signal
● While ON is selected for AUTO SEARCH item in OPTION menu (54), the
projector will keep checking the ports in above order repeatedly till an input
signal is detected.
●
It may take several seconds to project the images from the USB TYPE B port.
For a computer signal
NORMAL 4:3 16:9 16:10 NATIVE
For a video signal, s-video signal or component video signal
4:3 16:9 16:10 14:9 NATIVE
For an input signal from the LAN, USB TYPE A or USB TYPE B port, or
if there is no signal
CP-A221N, CP-A301N: 4:3 (xed)
CP-AW251N: 16:10 (xed)
Operating
For an HDMI
TM
signal
NORMAL 4:3 16:9 16:10 14:9 NATIVE
ASPECT button
To Next Page
Loading...
