Hitachi CP-AW3005 - Using the Cable Cover

16
Using the cable cover
Utilize the cable cover as the guard and blind for the connecting parts.
1.
Connect the signal cables and the power cord to the projector rst.
2.
Insert the three knobs on the cable cover into the
three holes on the projector as shown in the gure.
Pass the cables through the holes on the bottom of
the cable cover.
3
.
Fix the cover's screw.
Setting up
► Be careful not to pinch the cables in the cable cover, to
prevent damage to the cables.
► Use the cable cover that is supplied with the projector. Do not attempt any
modications to the cable cover.
CAUTION
1
3
knobs
1
2
3
screw
2