47
SETUP menu
Item Description
LAMP &
FILTER
LAMP TIME
The lamp time is the usage time of the lamp, counted after the
last resetting.
Pressing the RESET button on the remote control or the ►
button of the projector displays a dialog.
To reset the lamp time, select the OK using the ► button.
CANCEL
ð
OK
• Please reset the lamp time only when you have replaced the
lamp, for a suitable indication about the lamp.
• For the lamp replacement, see the section "Replacing the
lamp" (
96).
• The IMAGE OPTIMIZER function does not work properly
unless
LAMP TIME is initialized when replacing a lamp.
FILTER
TIME
The lter time is the usage time of the air lter, counted after the
last resetting.
Pressing the RESET button on the remote control or the ►
button of the projector displays a dialog.
To reset the lter time, select the OK using the ► button.
CANCEL
ð
OK
• Please reset the lter time only when you have cleaned or
replaced the air lter, for a suitable indication about the air lter.
• For the air lter cleaning, see the section “Cleaning and
replacing the air lter” (
98).
FILTER
MESSAGE
FILTER MESSAGE
Use the ▲/▼ button to set the timer for notifying by the message
when to replace the lter unit
100h
ó
• • •
ó
5000h
ó
OFF
After choosing an item except OFF, the message “REMINDER
*** HRS PASSED ....” will appear after the timer reaches the
interval time set by this feature (
103).
When the OFF is chosen, the message will not appear. Utilize
this feature to keep the air lter clean, setting the suitable time
according to your environment of this projector.
• Please take care of the lter unit periodically, even if there is no
message. If the air lter becomes to be blocked by dust or other
matter, the internal temperature will rise, which could cause
malfunction, or reduce the lifetime of the projector.
• Please be careful with the operating environment of the
projector and the condition of the lter unit.
To Next Page
Loading...
