46
13. Restart the projector.
CAUTION
Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
14. After the startup logo, open the On-Screen
Display (OSD) menu.
15. Go to the SYSTEM SETTING:
ADVANCED > Lamp Settings menu. Press
MODE/ENTER on the projector or remote
control. The Lamp Settings page is
displayed.
16. Press to highlight Reset lamp timer and
press MODE/ENTER on the projector or
remote control. A warning message is
displayed asking if you want to reset the lamp
timer.
17. Highlight Reset and press MODE/ENTER
on the projector or remote control. The lamp
time will be reset to '0'.
CAUTION
Do not reset if the lamp is not new or replaced as this
could cause damage.
11. Replace the lamp cover on the projector.
12. Tighten the screw that secures the lamp
cover.
CAUTION
• Loose screw may cause a bad connection,
which could result in malfunction.
• Do not over tighten the screws.
2
1
Reset Lamp Timer?
Reset
Cancel
Notice
To Next Page
Loading...
