How to fix a Hitachi CP-DX301 Projector that does not turn on?
If your Hitachi Projector does not turn on, ensure the power cord is securely plugged into both the AC inlet on the projector and a functioning power outlet, and that the power outlet switch is on. Also, if the projector is cooling down, wait until the process is complete before attempting to turn it on again.
What to do if my Hitachi Projector has no picture?
If your Hitachi Projector displays no picture, first ensure that the video source is turned on and correctly connected. Then, verify the projector is correctly connected to the input signal device. Finally, select the correct input signal using the SOURCE key on the projector or remote control.
How to fix a blurred image on my Hitachi CP-DX301 Projector?
If the image on your Hitachi Projector is blurred, adjust the focus of the lens using the focus ring. If the issue persists, adjust the projection angle, direction, and height of the projector to properly align it with the screen.
Why does my Hitachi CP-DX301 remote control not work?
If your Hitachi Projector remote control isn't working, start by replacing the battery with a new one. If that doesn't solve the issue, check for any obstructions between the remote and the projector and remove them. Also, make sure you are within 4 meters (approximately 13 feet) of the projector.
General| Resolution | 1024 x 768 (XGA) |
|---|---|
| Contrast Ratio | 2000:1 |
| Projection System | 3LCD |
| Screen Size | 30 - 300 inches |
| Zoom Ratio | 1.2x |
| Output Terminals | VGA |
| Brightness | 3000 ANSI Lumens |
| Input Terminals | HDMI |
| Noise Level | 29 dB (eco mode) |
| Operating Temperature | 5 - 35 °C |
To Next Page
