Hitachi CP-S830W - Page 7

CP-S830W
CP-S830E
Message table
On-screen display
The following messages are displayed on the screen.
"CHANGE THE LAMP"
“AFTER REPLACING LAMP, RESET |Lamp has 1,700 hours on it and may need to be changed.
THE LAMP TIMER"
"CHANGE THE LAMP"
"AFTER REPLACING LAMP,
RESET THE LAMP TIMER"
"THE POWER WILL TURN OFF
AFTER 20 Hr."
Blinking of "CHANGE THE LAMP"
"AFTER REPLACING LAMP,
RESET THE LAMP TIMER"
"THE POWER WILL TURN OFF
AFTER 0 Hr."
"NO INPUT IS DETECTED" Signal is not input.
"SYNC IS OUT OF RANGE" ihe penne frequency of the input signal exceeds the range of the projector,
it cannot be displayed.
Lamp has 1,979 hours on it.
See P.4 "Reset the lamp timer"
When the lamp has 2,000 hours or more on it, the message will blink, and the
power will turns off after 10 minutes.