Hitachi CP-S830W - Page 8

2P-S830W
>P-S830E
Indicator display
The ON indicator, LAMP indicator and TEMP indicator will light or blink in the following cases.
Lights orange | Goesoft___| Goes off | Stancbymode |
[Binks orange | Goes of | Goes of | Dumgcoaing down
If the indicator is still lit, lamp
Lights red Lights red Goes off
may be defective. Replace.
Lights red Blinks red Lamp is not inserted Securely insert the lamp.
. : baat : Correctly reinstall so as not to
Lights red Lights red de too hight
ights re Goes off ights re Temperature insi ig block ventilation holes.
Lights red Blinks red Cooling fan accidented Replace fan.
: ‘
Accumulated
lamp
operation
Replace
lamp
and
reset
the
Blinks
red
Blinks
red
Goes
off
time
has
exceeded
2,000
accumulated
lamp
operation
hours
time.
When inside temperature becomes high because ventilation holes are blocked, normally, TEMP indicator will
light red. However, to protect the projector, the lamp may be turned off and at this time LAMP indecator may
light red.
Cool projector by power off for
60 minutes.
Lamp cannot light