13
ENGLISH
 HIGH VOLTAGE
 HIGH TEMPERATURE  HIGH PRESSURE
WARNING Ź7KHSURMHFWRUXVHVDKLJKSUHVVXUHPHUFXU\JODVVODPS7KH
lamp can break with a loud bang, or burn out, if jolted or scratched, handled 
while hot, or worn over time. Note that each lamp has a different lifetime, and 
some may burst or burn out soon after you start using them. In addition, when 
WKHEXOEEXUVWVLWLVSRVVLEOHIRUVKDUGVRIJODVVWRÀ\LQWRWKHODPSKRXVLQJ
and for gas containing mercury to escape from the projector’s vent holes.
ŹAbout disposal of a lamp: This product contains a mercury lamp; do not put 
it in a trash. Dispose of it in accordance with environmental laws. 
)RUODPSUHF\FOLQJJRWRwww.lamprecycle.org (in the US).
)RUSURGXFWGLVSRVDOFRQVXOW\RXUORFDOJRYHUQPHQWDJHQF\
or www.eiae.org (in the US) or www.epsc.ca (in Canada).
)RUPRUHLQIRUPDWLRQDVN\RXUGHDOHU
,IWKHODPSVKRXOGEUHDNLWZLOOPDNHDORXGEDQJZKHQLWGRHV
unplug the power cord from the outlet, and make sure to request a 
replacement lamp from your local dealer. Note that shards of glass 
could damage the projector’s internals, or cause injury during handling, 
so please do not try to clean the projector or replace the lamp yourself.
,IWKHODPSVKRXOGEUHDNLWZLOOPDNHDORXGEDQJZKHQLWGRHV
ventilate the room well, and make sure not to breathe the gas that 
comes out of the projector vents, or get it in your eyes or mouth.
%HIRUHUHSODFLQJWKHODPSWXUQWKHSURMHFWRURIIDQGXQSOXJWKHSRZHU
cord, then wait at least 45 minutes for the lamp to cool sufficiently. 
Handling the lamp while hot can cause burns, as well as damaging the lamp.
1HYHUXQVFUHZH[FHSWWKHDSSRLQWHGPDUNHGE\DQDUURZVFUHZV
'RQRWRSHQWKHODPSFRYHUZKLOHWKHSURMHFWRULVVXVSHQGHGIURP
a ceiling. This is dangerous, since if the lamp’s bulb has broken, the 
shards will fall out when the cover is opened. In addition, working in 
high places is dangerous, so ask your local dealer to have the lamp 
replaced even if the bulb is not broken.
'RQRWXVHWKHSURMHFWRUZLWKWKHODPSFRYHUUHPRYHG$WWKHODPS
replacing, make sure that the screws are screwed in firmly. Loose 
screws could result in damage or injury.
8VHRQO\WKHODPSRIWKHVSHFL¿HGW\SH
,IWKHODPSEUHDNVVRRQDIWHUWKHILUVWWLPHLWLVXVHGLWLVSRVVLEOH
that there are electrical problems elsewhere besides the lamp. If this 
happens, consult your local dealer or a service representative.
Handle with care: jolting or scratching could cause the lamp bulb to burst during use.
8VLQJWKHODPSIRUORQJSHULRGVRIWLPHFRXOGFDXVHLWGDUNQRWWROLJKW
up or to burst. When the pictures appear dark, or when the color tone 
is poor, please replace the lamp as soon as possible. Do not use old 
(used) lamps; this is a cause of breakage. 
Disconnect
the plug 
from the 
power
outlet
Replacing the lamp (continued)