50
SECURITY menu
Item Description
TRANSITION
DETECTOR
If this function is set to the ON when the vertical angle of
the projector or the MIRROR setting at which the projector
is turned on is different than the previously recorded, the
TRANSITION DETECTOR ON alarm will be displayed and
the projector will not display the input signal.
• To display the signal again, set this function to the OFF.
• After about 5 minutes of displaying the TRANSITION DETECTOR ON
alarm, the lamp will turn off.
• Keystone adjustment feature has been prohibited as long as the Transition
Detector function is on.
1 Turning on the TRANSITION DETECTOR
1-1
Use the Ÿ/ź cursor buttons on the SECURITY
menu to select the TRANSITION DETECTOR
and press the Ź cursor (or the ENTER) button to
display the TRANSITION DETECTOR on/off menu.
1-2
Use the Ÿ/ź
cursor
buttons on the
TRANSITION DETECTOR on/off menu
to select
the
ON. Select
the
ON and the
current angle and
the
MIRROR setting will
be recorded. The ENTER NEW PASSWORD
box (small) will be displayed.
1-3
Use the Ÿ/ź/Ż/Ź cursor buttons to enter a
password. Move the cursor to the right side
of the ENTER NEW PASSWORD box (small)
and press the Ź cursor (or the ENTER)
button to display the NEW PASSWORD
AGAIN box, enter the same password again.
1-4 Move the cursor to the right side of the NEW
PASSWORD AGAIN box and press the Ź
cursor (or the ENTER) button to display the
NOTE NEW PASSWORD box for about 30
seconds, please make note of the password
during this time.
Pressing the Ź cursor (or the ENTER) button will return to the TRANSITION
DETECTOR on/off menu.
• Please do not forget your TRANSITION DETECTOR password.
•
This function will activate only when the projector is started after turning off the AC power.
• This feature may not function properly if the projector is not in a stable
position when the ON is selected.
2 Turning off the TRANSITION DETECTOR
2-1
Follow the procedure in 1-1 to display the TRANSITION DETECTOR on/off menu.
2-2
Select
the
OFF to display the ENTER
PASSWORD box (large). Enter the registered
password and the screen will return to the
TRANSITION DETECTOR on/off menu.
If an incorrect password is input, the menu will
close. If necessary, repeat the process from 2-1.
3 If you have forgotten your password
3-1
Follow the procedure in 1-1 to display the TRANSITION DETECTOR on/off menu.
3-2 Select the OFF to display the ENTER PASSWORD box (large). The 10
digit Inquiring Code will be displayed inside the box.
3-3 Contact your dealer with the 10 digit Inquiring Code. Your password will
be sent after your user registration information is confi rmed.
(continued on next page)
ENTER NEW PASSWORD
box (small)
ENTER PASSWORD box
(large)
To Next Page
Loading...
