English
14
䡬
When the trigger switch is depressed, the tool
rotates. When the trigger is released, the tool stops.
䡬
The rotational speed of the drill can be controlled by
varying the amount that the trigger switch is pulled.
Speed is low when the trigger switch is pulled slightly
and increases as the trigger switch is pulled more.
䡬
When releasing the trigger of the switch, the brake
will be applied for immediate stopping.
8. Switch operation
䡬
When the trigger switch is depressed, the tool
rotates. When the trigger is released, the tool stops.
䡬
The rotational speed of the drill can be controlled by
varying the amount that the trigger switch is pulled.
Speed is low when the trigger switch is pulled slightly
and increases as the trigger switch is pulled more.
NOTE:
䡬
A buzzing noise is produced when the motor is about
to rotate. This is only a noise, not a machine failure.
9. Using the light
Pull the trigger switch to light up the light. The light
keeps on lighting while the trigger switch is being
pulled. The light goes out after releasing the trigger
switch. (Fig. 9)
THE SCOPE AND SUGGESTIONS FOR USES
Table 6
CAUTION:
Do not look directly into the light. Such actions
could result in eye injury.
10. Battery level warning lamp
The battery level can be checked by pulling the
trigger switch while the power tool is in a no-load
state. The battery level warning lamp lights when
the battery power is very low. If this happens, charge
the battery. (Fig. 10)
Fig. 8
Selector
button
R
marks
L
marks
Trigger
switch
Fig. 9
Work
Clutch dial position
Suggestions
Drilling Wood
Use for drilling purpose.
Small
1 – 21
Use the bit and socket matching the screw
Screw
screw diameter.
tightening
Wood
1 –
Use after drilling a pilot hole.
screw
Trigger switch
Light
NOTE:
䡬
The level at which the battery level warning lamp
lights may vary due to the ambient temperature,
characteristics of the battery, etc. and is intended
only as a guide.
䡬
The battery level warning lamp may light when the
power tool is overloaded. This does not mean that
the battery power is very low.
Be sure to check the battery level while the tool is in
a no-load state.
Fig. 10
Battery level
warning lamp
01Eng_DB10DL_US 10/12/07, 09:3714
To Next Page
Loading...
