EasyManua.ls Logo

Hitachi DT-P300GX - Page 4

Hitachi DT-P300GX
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
Prohibition
หาม
Do not touch the pump motor while the pump is
running. หามสัมผัส Motor ปมนํ้าในขณะเดินเครื่อง
Due to the high temperature, it may cause a scald.
เนื่องจากอุณหภูมิสูงอาจทําใหเกิดการพุพองได
Caution
ระวัง
While maintaining this product you should wear
gloves. การบํารุงรักษาผลิตภัณฑนี้ ควรสวมถุงมือ
ในขณะปฏิบัติงาน
To prevent possible injury. เพื่อปองกันการ
บาดเจ็บที่อาจเกิดขึ้นได
Caution
ระวัง
Check the ground whether it has good water
drainage. ตรวจสอบดูวาที่พื้นมการปองกนนํ้าหรือ
การระบายนํ้าดีหรือไม
Otherwise, in the case of a water leak, it may
cause damage to the pump. กรณีเกิดนํ้ารั่ว
อาจสงผลใหเกิดความเสียหายได
Prohibition
หาม
Do not dry run it. หามเดนเครื่องโดยไมมีนํ้า (Dry Run)
Prohibition
หาม
Do not use the pump with other liquids except clean
water such as oil, thinner or hot water at 40°C or more.
หามนาปมนี้ไปใชกับของเหลวอื่น นอกจาก นํ้าสะอาด
เชน นํ้ามัน, ทินเนอร หรอนํ้ารอนที่อุณหภูมิมากกว 40°C
Caution
ระวัง
Check the site of installation. ตรวจสอบพื้นที่
การติดตั้งปมนํ้า
Avoid sites that are easily ooded, as it may
cause damage to the pump. หลีกเลี่ยงบริเวณ
พื้นที่มีนํ้าทวมขังไดงาย เพราะอาจทําใหเกิดความ
เสียหายกับปม
COVER
WATER-PROTECTING
TRAY ถาดกั้นนํ้า
DRAIN PIPE
ทอระบายนํ้า
1 Be careful after lling water, tighten the hopper cap to prevent leaking water.
ระมัดระวัง หลังจากเติมนํ้าลอเสร็จแลว ควรขันฝาจุกปด ( Hopper cap ) ใหแนน
ไมใหเกิดนํ้ารั่วออกมา
2 Check the possibility of leaking in step of installing pump (by turning on pump)
with certainty before closing the cover. ควรทําการเช็ครอยรั่วที่อาจเกิดขึ้นจากการ
ติดตั้งของปมนํ้า ( โดยเดินเครื่องปมนํ้า ) ใหแนใจกอนทําการปดฝาครอบปมนํ้า
3 Do not open the cover while using. ไมควรเปดฝาครอบปมนํ้าออกขณะใชงาน
Please read the operational manual with understanding before installing and using Pump. โปรดอานคูมือใหเขาใจ กอนทาการตดตั้งปมนํ้าและ
กอนการใชงาน
The water left in the pump may overheat and cause damage.
นํ้าที่คางอยูภายในตัวปมจะรอนทําใหเปนสาเหตุของความเสียหายไดเชน
ชิ้นสวนพลาสติก
PRECAUTIONS
ขอควรระวัง
CAUTION
ขอควรระวัง
Otherwise, it may cause injury or a short circuit.
อาจเกิดการบาดเจ็บ
หรือไฟฟาชอตจากการเสียหายได
Components of the pump, such as plastic, rubber
parts, can be damaged.
อาจทําใหชิ้นสวนไดรับ
ความเสียหายได เชน
พลาสติก, ยาง
The area where there
is stagnant water
บริเวณนํ้าขัง
40 C
OIL
When installation of the pump is made, please check for leaking water.
เมื่อทาการตดตั้งกรณาตรวจสอบวาไมมีนํ้ารั่วเกดขึ้น
3PPL063166-A.indd 43PPL063166-A.indd 4 07/21/11 9:06 AM07/21/11 9:06 AM

Related product manuals