What to do if the ALARM LED is on due to a temperature problem in Hitachi HUS VM?
If the ALARM LED is on and you suspect a temperature issue, power down the Hitachi storage system. Reduce the room temperature to the specified operating range, and then power the system back on. If the problem persists, contact the support center for assistance with power cycling.
What to do if there is a general power failure in Hitachi HUS VM?
In the event of a general power failure with your Hitachi Storage, turn off all PDU switches and breakers. Once the facility power is stable, turn them back on and power up the system. If you need further assistance, contact Hitachi Data Systems support.
What to do if a fence message is displayed on the console of Hitachi HUS VM Storage?
If you see a fence message displayed on the console of your Hitachi Storage, first determine if there is a failed storage path. If a failed path exists, toggle the RESTART switch and retry the operation. If the fence message reappears, contact the support center for further assistance.
How to troubleshoot an error message displayed on Hitachi HUS VM Storage?
To address an error message displayed on your Hitachi Storage, first identify the type of error using the SIM codes section. If possible, resolve the underlying cause of the error. If you are unable to correct the error, contact the support center for assistance.
Describes system configurations using both in-band and out-of-band methods for connecting to CCI servers.
Details how CCI enables user authentication using operation authority and the mandatory nature of this function for certain operations.
Provides instructions for starting CCI instances on UNIX systems, covering both single and multiple instances.
Details the steps for starting CCI instances on Windows systems, including single and multiple instances.
Explains how to create LDEVs of virtual volumes for Dynamic Provisioning and make them available to hosts.
Details how Server Priority Manager prioritizes host I/O operations for high-speed processing on specified hosts.
Describes how CCI allows performing ShadowImage and TrueCopy operations by issuing commands from the host to the RAID storage system.
Provides general advice for troubleshooting CCI software issues, including checking server hardware/software and restarting servers.
Details system log messages and command error messages, providing recommended actions for resolving error conditions.
To Next Page
General