To Next PageTo Next Page
Need help?Do you have a question about the Hitachi HTS542516K9SA00 and is the answer not in the manual?
Defines abbreviations used in the document.
Provides important warnings and precautions for handling the drive.
Details specific precautions for handling the hard disk drive.
Describes the functions of the drive's control electronics.
Presents formatted capacity data for different drive models.
Provides a datasheet with various drive specifications.
Outlines key parameters characterizing drive performance.
Explains potential data loss scenarios during power loss.
Details the write cache feature and its implications for data integrity.
Describes the drive's error recovery procedures.
Specifies environmental operating and non-operating conditions.
Outlines the nominal supply and voltage specifications.
Covers data reliability and failure prediction.
Covers physical dimensions and weight of the drive.
Shows the physical pin location of the interface connector.
Lists pin assignments of interface signals and their I/O.
Describes the host interface and its conformance to standards.
Defines naming conventions for registers per ATA8-ACS and Serial ATA.
Details the Device Control Register and its bit definitions.
Describes the Error Register for status and diagnostic codes.
Details the Status Register and its bit definitions.
Explains the three types of ATA resets and their responses.
Addresses load/unload and emergency unload during power-off.
Explains Logical CHS and LBA addressing modes.
Details the ABLE-3 feature for intelligent power management.
Lists commands that transfer data from the device to the host.
Lists commands that do not involve data transfer.
Describes DMA commands for high-performance data transfer.
Reports whether the device is spun up and media is accessible.
Details feature set commands for device configuration overlay.
Performs internal diagnostic tests and stores results in Error Register.
Requests device to transfer configuration information to the host.
General