Hitachi KH335BE - DAB Operation; Full Scan; Software Version

GB
16
DAB Operation
If the unit is connected to the mains power and then switched
on for the rst time, the unit will automatically enter into the
DAB mode and perform auto scan. During the scan the display
will show “Scanning ...” together with a slide bar that indicates
the progress of the scan and the number of stations that have
been found so far.
Once the scan has nished, the unit will select the rst
alphanumerically found station. To explore the found stations,
press and then to conrm selection.
Full Scan
The full scan will search for the entire DAB Band III channels.
After the scan has nished, the rst alphanumerically found
station will be automatically selected.
Full scan will not replace the DAB stations in memory. If you want to
remove all the previously scanned stations, factory reset is required.
Software Version
1. Press MENU and then repeatedly to select <System>.
Press to conrm.
2. Press repeatedly to select <SW version>. Press to
conrm.
3. Press MENU to exit.