Hitachi LP-WU6500 - Page 19

Projector parts and functions
English-19
I/O Port (Input / Output)
1. HDMI 1 (Digital audio/video connector)
Connect to HDMI or DVI source.
2. RJ45
Connect a LAN cable from Ethernet.
3. HDMI 2 (Digital audio/video connector)
Connect to HDMI or DVI source.
4. HDBaseT (RJ-45 jack)
Connect to HDBaseT source via LAN
cable.
5. HDMI 3 / MHL (Digital audio/video
connector)
Connect to a HDMI or MHL-compatible
device.
6. MONITOR OUT (D-sub 15-pin mini
shrink jack)
Connect to a monitor.
Loop through only for COMPUTER.
7. COMPUTER (D-sub 15-pin mini shrink
jack)
Connect to a PC.(Support RGB and
component video signal input).
8. VIDEO (RCA jack)
Connect to the composite video device.
9. 3D SYNC (VESA 3-pin)
Connect to 3D IR glasses receiver unit.
10. SERVICE
For service personnel only.
11. USB POWER (USB A type jack)
Connect a USB device. (Support 5V/1.5A
output while the projector Power On.)
12. AC
Connect a POWER cable.
13. RS-232C (9-pin D-sub socket) (Cross
cable)
Connect your PC or system control
equipment.
14. AUDIO OUT (3.5 mm, mini jack)
Connector to an audio amplier device.
15. AUDIO IN (3.5 mm, mini jack)
Connect an audio source input. (Available
for Computer, BNC, DVI-D source.)
16. AUDIO IN (L/R) (RCA jack)
Connect an audio source. (Available for
Video signal input.)