Projector installation
English-38
Powering the projector on or off
Powering on the projector
Press on the projector or on the remote control to start up the projector.
The POWER LED will now ash green. The startup screen will display in approximately 10 seconds.
The rst time you use the projector, you can select your preferred language from the quick menu after
the startup screen display.
If security lock is enabled, refer to Page 40 : “Setting an access password (security lock)”.
Connect the power cord to the projector
Turning off the projector
Press on the projector or on the remote control. The message “Power Off? /Press Power
again” will appear on the screen. Press the button again while the message appears. When the
projector has been turned off, the cooling fan will remain in operation for approximately 5 seconds.
To Next Page
Loading...
