Hitachi M 12V - Cutting Operation Procedures; Trimmer Guide Usage

4. Cutting
(1)
As
shown in
Fig. 17,
remove the
bit
from the work
pieces
and press the switch
lever up to the ON
position.
Do not start cutting operation
until
the bit
has reached full rotating
speed.
(2)
The bit rotates
clockwise (arrow
direction
indicated
on
the
base).
To
obtain
maximum
cutting effective-
ness,
feed
the
router
in conformance
with the feed
directions
shown
in
Fig.
18.
Fig.
18
USING
THE
OPTIONAL
ACCESSORIES
Fig.
19
1.
Model
M12V, Ml
2SA
(1
)
Trimmer
Guide
:
Use
the trimmer guide for chamfering.
As
shown
in
Fig.
19 use
the wing bolt
to
mount
and
secure
the
trimmer
guide
on the
bar
holder.
Use the two
wing bolts
to
align the
trimmer guide in
the
desired position,
and
use it as shown in
Fig.
20.
2. Model
M8V,
M8
(1
) Trimmer Guide
:
Use
the trimmer
guide
for trimming,
chamfering or
working
the
inner surface.
Attach the
trimmer guide
to
the base
as
shown
in
Fig
. 21.
After aligning
the
roller
to
the appropriate position,
tighten the two wing bolts (A) and the
other
wing
bolt
(C). Use as
shown in
Fig.
22.
13