Hitachi M 8V2 - Standard Accessories; Optional Accessories

*
ALTERNATIVE PARTS
--- 4 --- 3 -- 06
OPTIONAL ACCESSORIES
ITEM
NO.
CODE NO.
DESCRIPTION
REMARKS
NO.
USED
STANDARD ACCESSORIES
ITEM
NO.
CODE NO.
DESCRIPTION
REMARKS
NO.
USED
M 8V2
Printed in Japan
(060328N)
501 956-797 STRAIGHT GUIDE 1
502 971-622 GUIDE BAR 2
503 301-806 WING BOLT M6X15 2
504 323-295 WRENCH 23MM 1
* 505 326-095 CASE 1 EXCEPT FOR AUT, USA, CAN
* 506 971-852 CHUCK SLEEVE 8X6 1 FOR EUROPE, FIN, NOR, SWE, DEN
507 326-091 BAR HOLDER 1
508 949-394 WING BOLT M6X10 (10 PCS.) 1
509 956-793 FEED SCREW 1
601 997-466 DUST COLLECTION ADAPTER SET 1 INCLUD. 602, 603
602 997-467 KNOB NUT 2
603 949-237 MACHINE SCREW M5X12 (10 PCS.) 2
604 956-794 TRIMMER GUIDE 1
605 318-304 ADJUSTING KNOB SET 1 INCLUD. 606-609
606 318-350 SQUARE NUT 1
607 317-300 SLEEVE 1
608 956-046 WASHER (B) 1
609 971-858 SPRING (A) 1
* 610 956-808 STRAIGHT BIT (TCT) D8X8 1
* 610 971-878 STRAIGHT BIT (TCT) D1/4"X1/4" 1 FOR NZL, AUS, GBR, USA, CAN
*611 956-756 TEMPLATE GUIDE ADAPTER 1 FOR USA, CAN
* 612 323-298 TEMPLATE GUIDE D7.9 1 FOR USA, CAN
* 613 323-299 TEMPLATE GUIDE D9.5 1 FOR USA, CAN
* 614 323-300 TEMPLATE GUIDE D11.1 1 FOR USA, CAN
* 615 323-301 TEMPLATE GUIDE D12.7 1 FOR USA, CAN
* 616 323-302 TEMPLATE GUIDE D15.9 1 FOR USA, CAN
* 617 323-303 TEMPLATE GUIDE D19.1 1 FOR USA, CAN
* 618 323-304 TEMPLATE GUIDE D20.2 1 FOR USA, CAN
619 303-347 TEMPLATE GUIDE D9.5 1
620 303-348 TEMPLATE GUIDE D10 1
621 303-349 TEMPLATE GUIDE D11.1 1
622 303-350 TEMPLATE GUIDE D12 1
623 303-351 TEMPLATE GUIDE D12.7 1
624 303-352 TEMPLATE GUIDE D14 1
625 303-353 TEMPLATE GUIDE D16 1
626 303-354 TEMPLATE GUIDE D24 1
627 303-355 TEMPLATE GUIDE D40 1