What to do if my Hitachi P13F Planer will not operate?
If your Hitachi Planer won't operate, first, have a qualified electrician check the power source. Second, turn the planer off and reset the motor overload protection. Lastly, have a qualified electrician check the switch and wiring.
How to prevent snipe on Hitachi P13F?
Snipe (gouging at the ends of the board) on your Hitachi Planer can occur due to several reasons. It may be due to dull blades, which require replacement. Long boards may not be adequately supported. Uneven force on the cutterhead, or the rollercase not being level with the base, can also cause this. Lumber not butted properly may be another cause. Support long boards. Gently push the board when it is in contact with only one feed roller. Adjust the rollercase. Butt each piece of stock end-to-end as boards pass through the planer.
Why does my Hitachi P13F Planer cause torn grain?
Torn grain when using the Hitachi Planer can result from several factors: taking too heavy a cut, blades cutting against the grain, or dull blades. Review the operation of the planer. Replace the blades according to the instructions.
What causes rough raised grain on Hitachi P13F Planer?
Rough raised grain when using the Hitachi Planer can be caused by dull blades, taking too heavy a cut, or the wood having a moisture content that is too high. Replace the blades per the instructions. Review the operation of the planer. Dry the wood or use dried wood.
What to do if board stops moving past outfeed roller on Hitachi P13F?
If the board feeds inside your Hitachi Planer but stops moving past the outfeed roller, it could be due to a couple of reasons. The outfeed rollers may not be able to rotate because of clogging with chips, or there may be too much pressure on the cutterhead from a long workpiece. Clear the clogging, use a dust collector chip chute. Use support stands to support workpieces longer than 24”.
Why is it hard to adjust the rollercase on my Hitachi P13F?
If the rollercase elevation on your Hitachi Planer adjusts with difficulty, it could be due to several reasons: dirty gears, dirty elevation screws, worn gears or elevation screws, friction between the rollercase and covers, the rollercase not being parallel with the planer base, or the rollercase lock being engaged. Clean and lubricate the gears and elevation screws. Replace the gears and elevation screw if worn. Clean and lubricate where there is friction. Adjust the rollercase. Release the rollercase lock.
What causes fuzzy grain when using Hitachi P13F Planer?
Fuzzy grain when using the Hitachi Planer is caused by planing wood with a high moisture content. Remove high moisture content from wood by drying.
Why doesn't board thickness match depth of cut scale on Hitachi Planer?
If the board thickness does not match the depth of cut scale on your Hitachi Planer, it is because the indicator is not set correctly. Adjust the indicator and tighten securely.
What causes chain jumping on Hitachi Planer?
Chain jumping on your Hitachi Planer is caused by worn sprockets or a worn chain. Replace the sprockets or replace the chain.
Why is the belt slipping on my Hitachi Planer?
A slipping belt on your Hitachi Planer is due to a loose belt. Replace the belt, see Replacing V-Belt.
Covers essential safety checks before operating the planer, including installation and preparation.
Safety guidelines for dressing properly, inspecting workpieces, planning cuts, and safe operation.
Guide for correctly setting the height of the planer knives using a setting gauge.
Detailed steps for performing thickness planing operations safely and effectively.
To Next Page
General
