Hitachi PC-ARF1 - Page 6

6
P5417086
3. Cut away the insulation at the end of the cable and
clamp the M3 solderless terminals (eld-supplied).
3. Attach the controller body to the mounted holding bracket.
Be careful not to pinch the cable when attaching it.
1. Prepare the optional eld-supplied Implanted
Junction Box.
B. When Using Junction Box
Optional M-size
Junction Box
M4 Screws
(Field-Supplied)
Optional S-size
Junction Box
Connect the terminals.
Remove
the protection film
.
2. Feed the cable through the conduit tubing in the wall.
4. Peel away the protective lm from the liquid crystal display.