P5417086
9
7. Select “Yes” and press “OK”.
The Test Run menu is displayed after the setting is
conrmed.
If “No” is selected, the screen returns to “4”.
• Setting from Test Run Menu
OK
Input/Output:01-03
Input 1 00 CN3 1-2
Input 2 00 CN3 2-3
Output1 00 CN7 1-2
Output2 00 CN7 1-3
Output3 00 CN8 1-2
Item Setting Connector
Adj. Entr RtrnSel.
Back
OK
Input/Output:01-03
Input 1 00 CN3 1-2
Input 2 00 CN3 2-3
Output1 01 CN7 1-2
Output2 00 CN7 1-3
Output3 00 CN8 1-2
Item Setting Connector
Adj. Entr RtrnSel.
Back
1. Press and hold “Menu” and “Back/Help” simultaneously
for at least three seconds during the normal mode (when
unit is not operated). The Test Run menu is displayed.
2. Select “Function Selection” or “Input/Output” from the
Test Run menu and press “OK”.
OK
Test Run Menu
Elevating Grille Setting
Input/Output
Thermistor Selection
Function Selection
01
/
03
Test Run
Entr RtrnSel.
Back
OK
Function Selection
01-01
All
01-02
01-03
01-04
Entr RtrnSel.
Back
3. Select the indoor unit by pressing “ ” and touch
“OK”.
(This screen is NOT displayed when the number of an
indoor unit connected with the controller is “1”.
In this case, “4” is displayed.)
Function Selection
4. Press “
” and select the item.
5. Press “ ” and change the setting.
Input/Output Setting
4. Press “
” and select the item.
5. Press “
” and change the setting.
OK
Confirm function
selection setting?
Function Selection:01-03
Yes No
Sel. Entr Rtrn
Back
6. Press “OK” so that the conrmation screen is displayed.
8. Press “Back/Help” on the Test Run menu to return to the
normal mode.
(Figure for Function Selection)
To set other units, press “Back/Help” at “4” and “5” so that the screen returns to “3”.
(If the number of an indoor unit connected with the controller is “1”, the screen returns to “1”.)
5. Function Selection and Input/Output Setting from the Controller
OK
b1 00
01
31
b2 00
b3 00
b4 00
b5 00
Item Setting
/
Adj. Entr RtrnSel.
Back
Function Selection:01-03
01
31
b1 00
b2 00
b3 01
b4 00
b5 00
Item Setting
/
Adj. Entr RtrnSel.
Back
OK Back