Hitachi PC-ARFG2-Z - 2. Installation Work

2. Installation Work
4
A16381H9HF
[Installation Procedures]
(1) Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket, push and turn
the slotted screwdriver to separate and remove the controller from the mounting plate.
Groove Part
Figure Seen from Bottom Side
Slotted
Screwdriver
Approx. 6mm
NOTE:
•
Do not insert the slotted screwdriver into the tab beside the groove. The tab may be damaged and the
advanced color wired remote controller cannot be installed.
Tabs for Attaching Controller
Mounting Plate
2. Installation Work
This manual is applied for common use of the wired remote controller(connnected in non-zoning or zoning
system). Refer to "Installation Work" of INSTALLATION & MAINTENANCE MANUAL of Premium Zoning Kit when
connected in Zoning system.
[Before Installation]
(1) This packing contains the following parts.
Name
PC-ARFG2-Z
Operation Manual
Installation & Maintenance
Manual
Screw
Appearance
M4 × 16mm
Qty. 1 1 1 2
(2) When installing two controllers one above the other, allow a gap of at least
50mm between the two.
more than 50mm