Hitachi PC-ARH1E - Page 26

No. Item Optional function
Individual
Setting
Settings Setting conditions Description
81
J8
Eco-operation ×
00
Function disabled
(factory setting)
When the unit is restarted by
the remote control switch, the
temperature automatically changes
to the setting temperature of “F5”
or “F6”.
Models:
RPF(I)-FSN2E
Not available, use at 00 conditions
01 Function enabled
82
J9
Not used -
00
- Use at 00 conditions
01
83
jA
Not Used - 00/01 - Use as 00 conditions
84
jb
Not Used - 00/01 - Use as 00 conditions
85
1
Not used -
00
-
Use at 00 conditions
01
86
2
Not used -
00
-
Use at 00 conditions
01
87
3
Not used -
00
- Use at 00 conditions
01
88
4
Not used -
00
- Use at 00 conditions
01
02
03
89
5
Detection level of the motion
sensor kit
○
00 Standard (factory setting)
Models:
RPF(I)-FSN2E
Not available, use at 00 conditions.
Thisparameterdenesthe
sensitiveness of the motion
sensor. The amount of activity in
the room is assessed according
to a different scale based on this
setting.
Detailed information about the
operation of the motion sensor
can be found in the technical
documentation of the indoor units.
01 High
02 Low
90
6
Selection of allowed
operation modes when the
control sensor of the indoor
unit is set by C8 function
○
00 All modes allowed
This function is used to select
the operation modes in which
the setting of C8 (use of remote
control switch sensor or remote
sensor on THM4 to control the
indoor unit) is enabled.
01 Only cooling/dry allowed
02 Only heating allowed
03 All modes allowed
91
7
Not used ○
00
- Use at 00 conditions
01
02
03
92
8
Control for the prevention of
condensation on the louvres.
○
00
Function disabled
(factory setting)
Condensation may occur around
air outlet during COOL/DRY
operationwithhorizontalairowor
downwardairowforlongperiods.
This function is used to prevent
condensation by moving the
louvre swing angle to the third step
automatically for 30 minutes every
1 hour.
(In RPK units, this function is
activated by means of DSW2-4
instead of the K8 optional function)
01 Function enabled
OPTIONAL FUNCTION
PMML0497 rev.1 - 12/2020
18