English
22
wheel.
f) Use extra caution when making a “pocket cut” into existing walls or other blind
areas.
The protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause
kickback.
SAFETY WARNINGS SPECIFIC FOR SANDING
OPERATIONS
a) Do not use excessively oversized sanding disc paper. Follow manufacturers
recomendations, when se lect ing sanding paper.
Larger sanding paper extending beyond the sanding pad presents a laceration hazard and
may cause snagging, tearing of the disc or kickback.
PRECAUTIONS ON USING DISC GRINDER
1. Never operate these power tools without Wheel Guards.
2. Use only a depressed center wheel of permissible peripheral speed 72 m/s
(4300 m/min) or more.
3. Correct use for safe operation.
4. Mounting the standard depressed center wheel.
5. Have a trial run before grinding commence.
6. Keep away from a revolving depressed center wheel.
7. Pay strict attention to sparks.
8. Do not leave the revolving Grinder unattended on the fl oor.
9. Follow the procedures of these Handling Instructions on depressed center wheel
replacement.
10. Avoid overload operation.
11. Do not push in the lock pin while the spindle is running.
12. Be careful those around one while operating.
SYMBOLS
WARNING
The following show symbols used for the machine. Be sure that you understand their
meaning before use.
Read all safety warnings and all instructions.
Always wear eye protection.
000Book_PDA-100K_ChS.indb 22000Book_PDA-100K_ChS.indb 22 2015/7/3 14:02:282015/7/3 14:02:28
To Next Page
Loading...
Need help?
General
