Hitachi PDA-100K User Manual

English
26
If the main unit is ac ci den tal ly bumped or dropped, make a careful check for cracks
or splits on the depressed center wheel before further use.
○ Do not press the lock pin when the equipment is turning. Also, do not turn on the
switch when the lock pin is pressed down.
ASSEMBLING AND DISASSEMBLING THE DEPRESSED
CENTER WHEEL (Fig. 2)
CAUTION
Be sure to switch power OFF and disconnect the attachment plug from the power
receptacle to avoid serious trouble.
(1) Turn the equipment upsidedown so that the
spindle will be facing up.
(2) Mount the wheel washer onto the spindle.
(3) Mount the protuberance of the depressed
center wheel onto the wheel washer.
(4) Mount the convex side of the wheel nut onto
the depressed center wheel, and screw the
wheel nut onto the spindle.
(5) As shown in Fig. 2 push in the lock pin to
prevent rotation of the spindle. Then, secure
the depressed center wheel by tightening the
wheel nut with the wrench.
CAUTION
Confi rm that the depressed center wheel is mounted fi rmly.
Confi rm that the lock pin is disengaged by pushing lock pin two or three times
before switching the power tool on.
○ Disassembling of the depressed center wheel is the reverse of assembling.
HOW TO INSTALL THE OPTIONAL ACCESSORIES
CAUTION
○ Be sure to switch power OFF and disconnect the plug from the power receptacle
to avoid serious trouble. When utilizing the optional accessories, keep the wheel
guard attached and wear protective glasses.
○ Do not use the optional accessories which exceed the designated external
diameter designated in the paragraph.
Wrench
Tighten
Convex
side
Lock pin
Wheel nut
Depressed
center wheels
Wheel washer
Notched part
Wheel guard
Spindle
Fig. 2
000Book_PDA-100K_ChS.indb 26000Book_PDA-100K_ChS.indb 26 2015/7/3 14:02:282015/7/3 14:02:28

Hitachi PDA-100K Specifications

General

Brand	Hitachi
Model	PDA-100K
Category	Grinder
Language	English