Hitachi PSC-A32MN - Page 18

DSW1 Setting
Combination of
PSC- A32MN with other
central controllers
Other central
controllers
Name 0RGHO DSW1 DSW2 DSW3 DSW4
Central Station EZ PSC-A64GT OFF OFF OFF OFF
Central Station mini PSC-A32MN OFF OFF OFF OFF
Central Station PSC-A64S OFF OFF OFF OFF
Centralised ON/OFF Controller PSC-A16RS OFF OFF OFF OFF
BMS Gateways
HC-A(8/64)MB Not compatible
HC-A16KNX Not compatible
KNX001 Not compatible
HARC-BX E (A/B) Not compatible
CSNET
CSNET Manager LT Not compatible
CSNET Manager XT Not compatible
CSNET WEB (1) OFF OFF OFF OFF
Without other central controllers OFF OFF OFF OFF
&KHFNFRPSDWLELOLW\OLPLWDWLRQVLQ&61(7:HE36&$:(%0DQXDO
2 Close the unit case until hearing a snapping sound, and make sure that the front and rear parts of the case close fully. At this
time, check that connection bands are not trapped between the front and the rear parts of the case.
a. Hook the tabs into the front side of the case.
b. The front side of the case will close when hooking up the tabs of the lateral and lower sides.
Front case
Rear case
Catch
for
¿[LQJ
Connection band
(6 catches)
To attach the touch pen holder
When attaching the touch pen holder to the controller,
insert the chip into any of the attaching holes for the
holder until hearing a click.
Copper
Hole for touch pen holder
Electrical wiring
PMML0332A rev.0 - 05/201510