Hitachi PSC-A32MN - Page 21

Item )XQFWLRQ
Demand Function Setting
This function is used for setting of “Demand Function” to the terminal of “Input 1”.
Operation state changes by demand signals such as operation stop, or thermo-OFF.
“Demand Function” is available under the following conditions.
1. Selecting “Demand Function” for “Input 1” at the “External Input/Output Setting” screen. (“Demand Function”
is not available without this setting.)
2. Selecting one of “Demand Function” No.1 to No.4 at “Demand Function Setting” screen.
Demand Function Setting This function is used for selecting the action for “Demand Function” control.
Selection of Group for
Demand Function
This function is used for selecting the target group for “Demand Function” control.
Button Setting
This function is used for specifying whether each button shall be shown or hidden.
7KLVIXQFWLRQDOVRLQFOXGHVWKHVSHFL¿FDWLRQRI³RQHWDS´RU³SUHVVDQGKROG´RSHUDWLRQVW\OHRIWKHWRXFKVFUHHQ
Contact Information Register This function is used for editing the contents of contact information.
ENGLISH
Operation
PMML0332A rev.0 - 05/201513