Hitachi PSC-A32MN - Page 37

5.2.2.2 'LVSOD\RI6SHFLÀHG%ORFN
1 Select the target block from the screen of “Monitor (All Groups)” or “Monitor (Block)”.
Monitor (All Groups) Monitor (Block)
(1) (1)
2 The groups in the selected block are displayed on the touchscreen. The operation status of each group is indicated by the colour
of the group, as shown below:
Green: Run
Grey: Stop
Red: Abnormal
3 Tap “Air Temp Display” to display the outside air temperature and the inlet temperature.
4 Tap “Display Condit.” to display the condition of the operation.
(2)
(3)
(4)
 N O T E
 ³%ORFN´VFUHHQPD\EHGLIIHUHQWGHSHQGLQJRQWKH&RQWURO3DWWHUQ7KHVFUHHQRQWKHOHIWFRUUHVSRQGVWRWKHGLVSOD\RI3DWWHUQ$%ORFNVî
*URXSVDVVHWE\&RQWURO3DWWHUQ
 7KHWRXFKVFUHHQGLVSOD\LVSXWWRVOHHSPRGHDXWRPDWLFDOO\ZKHQWKHWRXFKVFUHHQLVQRWRSHUDWHGIRUDJLYHQOHQJWKRIWLPH7DSWKHVFUHHQWR
ZDNHXS
 ,WPD\WDNHWLPHWRGLVSOD\WKHWHPSHUDWXUH
 7KHLQOHWWHPSHUDWXUHLVGLVSOD\HGRQO\ZKLOHRSHUDWLQJ
ENGLISH
Operation
PMML0332A rev.0 - 05/201529